Diagnose Chain Length For Bike Derailleurs

Step of 4: Fit And Set Up A Bike’s Front Derailleur

Introduction

Any single-speed or standard derailer chain can be connected with chain tool. Narrow 9, 10 or '11 speed' chains have plates that are too thin to make this a reliable process and connect with special links that are supplied with them. Some chains – for example Shimano - have to be broken and reconnected with a special pin. Others with a trick link that can be dismantled by hand.

Step 1

<h3>Step 1</h3><p>Run the chain around the two biggest cog wheels, the fastest at the front and slowest at the back. Don’t thread it through the derailleurs. Find the shortest length that would connect and add on 1 inch, one complete inner and outer link. This is usually the ideal length for modern derailleur systems.
</p></div>

Long Enough for derailleurs?

Run the chain around the two biggest cog wheels, the fastest at the front and slowest at the back. Don’t thread it through the derailleurs. Find the shortest length that would connect and add on 1 inch, one complete inner and outer link. This is usually the ideal length for modern derailleur systems.

Step 2

<h3>Step 2</h3><p>Thread the chain through the derailleurs and round the two smallest cog wheels, the slowest at the front and the fastest at the back. Offer up the two ends of the chain and match the link that makes the chain short enough so that the bottom run of chain doesn’t rub on swing arm near the top jockey wheel on the rear derailleur.
</p></div>

Short Enough for derailleurs?

Thread the chain through the derailleurs and round the two smallest cog wheels, the slowest at the front and the fastest at the back. Offer up the two ends of the chain and match the link that makes the chain short enough so that the bottom run of chain doesn’t rub on swing arm near the top jockey wheel on the rear derailleur.

Pro Tip

In practice you never need to use either of these ‘oxymoronic’ gears, they are not at the extremes of the range and can be duplicated by other gears elsewhere in the system, but you don’t want the chain to jam in the derailleur system if they are selected mistakenly.